B2108 STEERING LOCK RELAY
Description
The steering lock relay ON signal is transmitted to IPDM E/R by BCM via CAN communication.
IPDM E/R turns the steering lock relay ON and transmits the release of the steering to BCM.
DTC Logic
DTC DETECTION LOGIC
NOTE:
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
Press the push-button ignition switch under the following conditions and wait for at least 1 second.
CVT selector lever is in the P position
Do not depress the brake pedal.
Check "Self diagnostic result" with CONSULT-III. Is DTC detected? YES >> Refer to Diagnosis Procedure.
NO >> Inspection End.
Diagnosis Procedure
1.CHECK FUSE
Turn ignition switch OFF.
Check 10A fuse (No. 40, located in IPDM E/R). Is the Inspection result normal? YES >> Replace IPDM E/R. Refer to See: Power and Ground Distribution\Power Distribution Module\Service and Repair .
NO >> Check the following.
Harness for open or short between IPDM E/R and battery
Fuse