B210D STARTER RELAY
Description
Located in IPDM E/R, it runs the starter motor. The starter relay is turned ON by the BCM when the ignition switch is in START position. IPDM E/R transmits the starter relay ON signal to BCM via CAN communication.
DTC Logic
DTC DETECTION LOGIC
NOTE:
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
Ignition switch ON under the following conditions and wait for at least 1 second.
CVT selector lever is in the P or N position
Do not depress the brake pedal
Check "Self diagnostic result" with CONSULT-III. Is DTC detected? YES >> Refer to Diagnosis Procedure.
NO >> Inspection End.
Diagnosis Procedure
1.CHECK STARTER RELAY POWER SUPPLY CIRCUIT
Turn ignition switch OFF.
Disconnect IPDM E/R harness connector.
Check voltage between IPDM E/R harness connector and ground.
Is the Inspection result normal?
YES >> Replace IPDM E/R. Refer to See: Power and Ground Distribution\Power Distribution Module\Service and Repair .
NO >> Check harness for open or short between IPDM E/R and battery.