Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » A L L Diagnostic Trouble Codes ( DTC ) » Testing and Inspection » B Code Charts » B26E1 » Coupe  
 
 
  Coupe  
 

B26E1 NO RECEPTION OF ENGINE STATUS SIGNAL

Description
BCM receives the engine status signal from ECM via CAN communication.

DTC Logic

DTC DETECTION LOGIC

NOTE:

  

DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE

  1. Turn ignition switch ON under the following conditions.
    • CVT selector lever is in the P or N position.
    • Do not depress the brake pedal.
  1. Check "Self diagnostic result" with CONSULT-III. Is DTC detected?

YES >> Refer to "Diagnosis Procedure".
NO >> Inspection End.

Diagnosis Procedure
1.Inspection START

  1. Turn ignition switch ON.
  2. Check "Self diagnostic result" with CONSULT-III.
  3. Touch "ERASE".
  4. Perform DTC Confirmation Procedure. See "DTC Logic".

Is the DTC B26E1 displayed again?
YES >> GO TO 2
NO >> Inspection End.
2.REPLACE ECM

  1. Replace ECM.
  2. Refer to See: Powertrain Management\Computers and Control Systems\Testing and Inspection\Programming and Relearning\Basic Inspection (VQ35DE), , "BASIC (QR25DE except California). >> Inspection End.