Your Vehicle: 2009 Nissan-Datsun Altima V6-3.5L (VQ35DE)
 
Vehicle » A L L Diagnostic Trouble Codes ( DTC ) » Testing and Inspection » B Code Charts » B1XXX  
 
 
  B1XXX  
 

B1XXX AIR BAG DIAGNOSIS SENSOR UNIT

Description

DTC B1XXX AIR BAG DIAGNOSIS SENSOR UNIT
The air bag diagnosis sensor unit will run self diagnostics when the ignition switch is turned ON. It has the potential to set many diagnostic trouble codes which will conform to the B1XXX format, but will not match any other SRS diagnostic trouble codes. Refer to See: Restraints and Safety Systems\Air Bag Systems\Testing and Inspection\Scan Tool Testing and Procedures\Diagnosis Sensor Unit\Trouble Diagnosis With CONSULT-III.

PART LOCATION
Refer to See: Restraints and Safety Systems\Air Bag Systems\Locations\SRS Air Bag System.

DTC Logic

DTC DETECTION LOGIC

With CONSULT-III

  

Without CONSULT-III

  

DTC CONFIRMATION PROCEDURE (With CONSULT-III)
1.Inspection START
Turn ignition switch ON.
>> GO TO 2.
2.CHECK SELF-DIAG RESULT
Check for the DTC on CONSULT-III.
Is the DTC detected?
YES >> Refer to Diagnosis Procedure (Component Diagnosis).
NO >> Inspection End.

DTC CONFIRMATION PROCEDURE (Without CONSULT-III)

NOTE:
SRS will not enter diagnosis mode if no malfunction is detected in user mode.
1.IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 2
2.IGNITION SWITCH
After air bag warning lamp lights for 7 seconds, turn ignition switch OFF within 1 second.
>> GO TO 3
3.WAIT TIME
Wait more than 3 seconds.
>> GO TO 4
4.REPEAT STEPS
Repeat steps 1 to 3 twice.
>> GO TO 5
5.IGNITION SWITCH
Turn ignition switch ON.
>> GO TO 6
6.DIAGNOSTIC MODE
SRS system is now in diagnostic mode and AIR BAG warning lamp flashes. Refer to See: Restraints and Safety Systems\Air Bag Systems\Testing and Inspection\Scan Tool Testing and Procedures\Diagnosis Sensor Unit\Trouble Diagnosis Without CONSULT-III.
>> END

Diagnosis Procedure (Component Diagnosis)
Recheck SRS after each replacement.
1.HARNESS CONNECTOR
Is there any visible damage to the connector?
YES or NO
YES >> Replace the harness.
NO >> GO TO 2
2.WIRING HARNESS
Is there any visible damage to the harness?
YES or NO
YES >> Replace the harness.
NO >> GO TO 3
3.AIR BAG DIAGNOSIS SENSOR UNIT
Replace the air bag diagnosis sensor unit. Refer to See: Relays and Modules\Relays and Modules - Restraints and Safety Systems\Air Bag Control Module\Service and Repair.
>> GO TO 4
4.RELATED HARNESS
Replace the related harness.
>> END